hi folks, after the bike (1980 xl1000) being off the road for a couple of months due to needing a new generator, regulator and starter gear I took her back out for a little run, it all seemed fine then a couple of miles along the road it started to rev really high and stuck there, I shut it down and when I tried to start it again it would only start and be stuck revving high, so it was pushed back to the garage, the throttle sleeve upon inspection needed replaced so I did that, but it just will not start, if I spray carb/ throttle body cleaner into the carb it fires up 1st time, its getting spark, when I disconnected the fuel hose going to the carb there was plenty fuel ( although maybe for some reason it is not getting into the carb?), if I had hair it would be getting pulled out as it is one problem directly after another since I bought this bike last summer, any ideas folks?
↧